Tube Spin Air (Click for more Info)

 Home  Products  Heat Exchanger / Boiler Repair & Re-Tubing Tools  Tube Pulling Equipment Tube Spin Air (Click for more Info)

Tube Spin Air (Click for more Info)

TUBE SPINAIR - PNEUMATIC TUBE TUGGER

Pneumatic tube spinner is designed to remove and flatten non-ferrous tubes from 5/8” to 1 ¼” OD. Can also be used to extract ferrous tubes from 5/8” to 1 ½” OD using special shaped rolls sized to fit each tube.

SPINAIR FEATURES:

  • Pulling rolls are made from tool steel and hardened for extended life.
  • High quality, strength construction body is made from aircraft grade aluminum and is anodized. for high corrosion resistance.
  • Nose piece and bearing caps are made from stainless steel for corrosion resistance.
  • Fully sealed bearings guarantee thousands of hours trouble free operation.

Model & Specifications

Model PULLING SPEED TORQUE PULLING FORCE AIR CONSUMPTION AIR PRESSURE MAX MOTOR POWER
TUBE SPINAIR-12 12 m/min 1183 Nm 872,25 Ft.Lbs 2,50 Ton 2 x 2300 l/min 2 × 75 cfm 6,2 bar 90 psi 2 × 3,0 Hp
TUBE SPINAIR-20 20 m/min 886 Nm 653,48 Ft.Lbs 1,80 Ton 2 x 2300 l/min 2 × 75 cfm 6,2 bar 90 psi 2 × 3,0 Hp
TUBE SPINAIR-40 40 m/min 960 Nm 708,06 Ft.Lbs 1,95 Ton 2 x 2800 l/min 2 × 95 cfm 6,2 bar 90 psi 2 × 3,5 Hp

 

TUBE SPINAIR - HYDRAULIC TUBE TUGGER

Hydraulic tube spinner SpinAir H is designed to remove and flatten non-ferrous tubes from 5/8” to 11/4” OD as standard. Can also be used to extract ferrous tubes from 5/8” to 11/2” OD using special shaped rolls sized to fit each tube. SpinAir H is supplied with heavy duty trans- port locker, hands tools for normal operation and user manual. Pulling rolls are made from tool steel and hardened for extended life. High quality, strength construction body is made from aircraft grade aluminum and is anodized for high corrosion resistance. Nose piece and bearing caps are made from stainless steel for corrosion resistance. Fully sealed bearings guarantee thousands of hours trouble free operation.

Specifications

  • Pulling Speed (depends on hydraulic pump): up to 70 meter per minute
  • Standard Configuration: 1” Non-Ferrous Tubes
  • Body construction: Aircraft grade aluminum, tool steel stainless.
  • Weight: 50 kg
  • Size:160 x 220 x 350 mm

Hydraulic Pump Requirements:

  • Min: 40 l/min at 2000 psi (gives approximately 30 m/min).
  • Max: 100 l/min at 2250 psi (gives approximately 70 m/min).
  • Forward and reverse oil flow.
  • It is recommended that the pump should be controlled by pedant with a forward and reverse lever attached to the Tube Traveller head. Variable flow control preferred.